User's Manual

User Manual

Fire ID TM-801-EN

Radiated RF

IEC 61000-4-3

3 V/m

80.0 MHz to 2.5 GHz

3 V/m

80.0 MHz to 2.5 GHz

Recommended separation

distance

Where P is the maximum

output power rating of the

transmitter in watts (W)

according to the transmitter

manufacturer and d is the

recommended separation

distance in meters (m).

Field strengths from fixed RF

transmitters, as deter-mined by

an electromagnetic site survey,

(a) Should be less than the

compliance level in each

frequency range (b).

Interference may occur in the

vicinity of

equipment marked with the

following symbol:

Note 1) At 80 MHz and 800 MHz, the higher frequency range applies.

Note 2) These guidelines may not apply in all situations. Electromagnetic propagation is affected by

absorption and reflection from structures, objects and people.

a Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and

land mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted

theoretically with accuracy. To assess the electromagnetic environment due to fixed RF transmitters, an

electromagnetic site survey should be considered. If the measured field strength in the location in which the

EUT is used exceeds the applicable RF compliance level above, the EUT should be observed to

verifynormal operation. If abnormal performance is observed, additional measures may be necessary, such

as re-orienting or relocating the EUT.

b Over the frequency range 150 kHz to 80 MHz, field strengths should be less than [V1] V / m.

Recommended Separation Distances Between Portable and Mobile RF Communications

Equipment and the Fire ID system.

The Fire ID system is intended for use in an electromagnetic environment in which radiated RF

disturbances are controlled. The user of the Fire ID system can help prevent electromagnetic

interference by maintaining a minimum distance between portable and mobile RF

communications equipment (transmitters) and the Fire ID system as recommended below,

according to the maximum output power of the communications equipment.

Rated maximum output Separation distance (m) according to frequency of transmitter