User's Manual

User Manual
FireCR Spark TM-701-EN
17
reader.
3. Connect the other end of the cable to the USB2.0 / Ethernet port on the computer.
3.6.2. Connect the Power Cord
1. Connect the power cord to the reader, located on the rear side.
2. Connect the other end of the cord to a grounded power outlet.
DANGER
This equipment is indoor use only and all the communication
wirings are limited to inside of the building.
DANGER
This equipment must only be connected to supply mains with
protective earth. Use only a three-wire cord that has grounding.
This is a safety feature. If you are unable to insert the plug into
the outlet, contact your electrician to replace your obsolete outlet.
Do not defeat the safety purpose of the grounding-type plug.
WARNING
Socket-outlet shall be installed near the device and shall be easily
accessible.
Do not place the device where difficult to access to appliance inlet.
Do not unplug the power cord or turn the power switch off during
scanning.
DANGER
Do not use any power cord other than the power cord included
with the system. Doing so may lead to fire, electrical shock, or
electrocution.
WARNING
Do not pull out the USB / Ethernet cable during scanning.