Two-Way Radio User Manual

*
STEP
Beginning a step in an ABAQUS/Explicit analysis
References:
•
“Procedures: overview,” Section 6.1.1 of the ABAQUS Analysis User’s Manual
• *
END STEP
Optional parameter:
NAME
Set this parameter equal to the nam e used to identify the step on the output database. Step names in
the same input file must be unique.
NLGEOM
Set NLGEOM=YES (default) to indicate that geometric nonlinearity should be accounted for
during the step (stress analysis and fully coupled thermal-stress analysis only). Once the NLGEOM
option has been switched on, it will be active during all subsequent steps in the analysis. Set
NLGEOM=NO to perform a geometrically linear analysis during the current step.
The default value for the NLG EOM parameter in an ABAQUS/Explicit analysis is YES
unless the ABAQUS/Explicit analysis is a n import analysis, in whic h case the default value of the
NLGEOM parameter is the sam e as the value of the parameter at the time of import.
Optional data lines:
First line:
1. Subheading for this step.
The subheading can be several lines long, but only the first 80 characters of the first line will be saved
and pr inted as a subheading.
18.36–4
ABAQUS Version 6.1 Module:
ID:
Printed on: