Switch User Manual
Table Of Contents
- 00-1Cover.pdf
- 01-CLI Operation.pdf
- 02-Login Operation.pdf
- 1 Logging In to the Switching Engine
- 2 Logging In Through OAP
- 3 Logging In Through Telnet
- 4 Logging In from the Web-Based Network Management System
- 5 Logging In from NMS
- 6 Configuring Source IP Address for Telnet Service Packets
- 7 User Control
- 03-Configuration File Management Operation.pdf
- 04-VLAN Operation.pdf
- 1 VLAN Overview
- 2 VLAN Configuration
- 05-Auto Detect Operation.pdf
- 06-Voice VLAN Operation.pdf
- 07-GVRP Operation.pdf
- 08-Basic Port Configuration Operation.pdf
- 1 Basic Port Configuration
- Ethernet Port Overview
- Configuring Ethernet Ports
- Making Basic Port Configuration
- Configuring Port Auto-Negotiation Speed
- Setting the Ethernet Port Broadcast Suppression Ratio
- Enabling Flow Control on a Port
- Configuring Access Port Attribute
- Configuring Hybrid Port Attribute
- Configuring Trunk Port Attribute
- Disabling Up/Down Log Output on a Port
- Copying Port Configuration to Other Ports
- Configuring a Port Group
- Setting Loopback Detection for an Ethernet Port
- Configuring the Ethernet Port to Run Loopback Test
- Enabling the System to Test Connected Cable
- Configuring the Interval to Perform Statistical Analysis on Port Traffic
- Displaying and Maintaining Ethernet Ports
- Ethernet Port Configuration Example
- Troubleshooting Ethernet Port Configuration
- 1 Basic Port Configuration
- 09-Link Aggregation Operation.pdf
- 1 Link Aggregation Configuration
- 10-Port Isolation Operation.pdf
- 11-Port Security-Port Binding Operation.pdf
- 1 Port Security Configuration
- Port Security Overview
- Port Security Configuration
- Displaying and Maintaining Port Security Configuration
- Port Security Configuration Example
- 2 Port Binding Configuration
- 1 Port Security Configuration
- 12-DLDP Operation.pdf
- 13-MAC Address Table Management Operation.pdf
- 14-MSTP Operation.pdf
- 1 MSTP Configuration
- STP Overview
- MSTP Overview
- Configuring Root Bridge
- Configuration Prerequisites
- Configuring an MST Region
- Specifying the Current Device as a Root Bridge/Secondary Root Bridge
- Configuring the Bridge Priority of the Current Device
- Configuring the Mode a Port Recognizes and Sends MSTP Packets
- Configuring the MSTP Operation Mode
- Configuring the Maximum Hop Count of an MST Region
- Configuring the Network Diameter of the Switched Network
- Configuring the MSTP Time-related Parameters
- Configuring the Timeout Time Factor
- Configuring the Maximum Transmitting Speed on the Current Port
- Configuring the Current Port as an Edge Port
- Specifying Whether the Link Connected to a Port Is Point-to-point Link
- Enabling MSTP
- Configuring Leaf Nodes
- Configuration Prerequisites
- Configuring the MST Region
- Configuring the Mode a Port Recognizes and Sends MSTP Packets
- Configuring the Timeout Time Factor
- Configuring the Maximum Transmitting Speed on the Current Port
- Configuring a Port as an Edge Port
- Configuring the Path Cost for a Port
- Configuring Port Priority
- Specifying Whether the Link Connected to a Port Is a Point-to-point Link
- Enabling MSTP
- Performing mCheck Operation
- Configuring Guard Functions
- Configuring Digest Snooping
- Configuring Rapid Transition
- Configuring VLAN-VPN Tunnel
- STP Maintenance Configuration
- Enabling Trap Messages Conforming to 802.1d Standard
- Displaying and Maintaining MSTP
- MSTP Configuration Example
- VLAN-VPN tunnel Configuration Example
- 1 MSTP Configuration
- 15-802.1x and System Guard Operation.pdf
- 1 802.1x Configuration
- Introduction to 802.1x
- Introduction to 802.1x Configuration
- Basic 802.1x Configuration
- Advanced 802.1x Configuration
- Displaying and Maintaining 802.1x
- Configuration Example
- 2 Quick EAD Deployment Configuration
- 3 System-Guard Configuration
- 1 802.1x Configuration
- 16-AAA Operation.pdf
- 1 AAA Overview
- 2 AAA Configuration
- AAA Configuration Task List
- RADIUS Configuration Task List
- Creating a RADIUS Scheme
- Configuring RADIUS Authentication/Authorization Servers
- Configuring RADIUS Accounting Servers
- Configuring Shared Keys for RADIUS Messages
- Configuring the Maximum Number of RADIUS Request Transmission Attempts
- Configuring the Type of RADIUS Servers to be Supported
- Configuring the Status of RADIUS Servers
- Configuring the Attributes of Data to be Sent to RADIUS Servers
- Configuring the Local RADIUS Authentication Server Function
- Configuring Timers for RADIUS Servers
- Enabling Sending Trap Message when a RADIUS Server Goes Down
- Enabling the User Re-Authentication at Restart Function
- HWTACACS Configuration Task List
- Displaying and Maintaining AAA
- AAA Configuration Examples
- Troubleshooting AAA
- 3 EAD Configuration
- 17-MAC Address Authentication Operation.pdf
- 18-IP Address and Performance Operation.pdf
- 19-DHCP Operation.pdf
- 1 DHCP Overview
- 2 DHCP Relay Agent Configuration
- Introduction to DHCP Relay Agent
- Configuring the DHCP Relay Agent
- Displaying and Maintaining DHCP Relay Agent Configuration
- DHCP Relay Agent Configuration Example
- Troubleshooting DHCP Relay Agent Configuration
- 3 DHCP Snooping Configuration
- DHCP Snooping Overview
- DHCP Snooping Configuration
- Configuring DHCP Snooping
- Configuring DHCP Snooping to Support Option 82
- DHCP-Snooping Option 82 Support Configuration Task List
- Enable DHCP-snooping Option 82 support
- Configure a handling policy for DHCP packets with Option 82
- Configure the storage format of Option 82
- Configure the circuit ID sub-option
- Configure the remote ID sub-option
- Configure the padding format for Option 82
- Configuring IP Filtering
- DHCP Snooping Configuration Example
- Displaying and Maintaining DHCP Snooping Configuration
- 4 DHCP/BOOTP Client Configuration
- 20-ACL Operation.pdf
- 1 ACL Configuration
- ACL Overview
- ACL Configuration
- ACL Assignment
- Displaying and Maintaining ACL
- Examples for Upper-layer Software Referencing ACLs
- Examples for Applying ACLs to Hardware
- 1 ACL Configuration
- 21-QoS-QoS Profile Operation.pdf
- 1 QoS Configuration
- Overview
- QoS Supported by Devices
- QoS Configuration
- QoS Configuration Task List
- Configuring Priority Trust Mode
- Configuring Priority Mapping
- Setting the Priority of Protocol Packets
- Marking Packet Priority
- Configuring Traffic Policing
- Configuring Traffic Shaping
- Configuring Traffic Redirecting
- Configuring VLAN Mapping
- Configuring Queue Scheduling
- Collecting/Clearing Traffic Statistics
- Enabling the Burst Function
- Configuring Traffic Mirroring
- Displaying and Maintaining QoS
- QoS Configuration Example
- 2 QoS Profile Configuration
- 1 QoS Configuration
- 22-Mirroring Operation.pdf
- 23-ARP Operation.pdf
- 24-SNMP-RMON Operation.pdf
- 25-Multicast Operation.pdf
- 1 Multicast Overview
- 2 IGMP Snooping Configuration
- IGMP Snooping Overview
- IGMP Snooping Configuration
- IGMP Snooping Configuration Task List
- Enabling IGMP Snooping
- Configuring the Version of IGMP Snooping
- Configuring Timers
- Configuring Fast Leave Processing
- Configuring a Multicast Group Filter
- Configuring the Maximum Number of Multicast Groups on a Port
- Configuring IGMP Querier
- Suppressing Flooding of Unknown Multicast Traffic in a VLAN
- Configuring Static Member Port for a Multicast Group
- Configuring a Static Router Port
- Configuring a Port as a Simulated Group Member
- Configuring a VLAN Tag for Query Messages
- Configuring Multicast VLAN
- Displaying and Maintaining IGMP Snooping
- IGMP Snooping Configuration Examples
- Troubleshooting IGMP Snooping
- 3 Common Multicast Configuration
- 26-NTP Operation.pdf
- 1 NTP Configuration
- Introduction to NTP
- NTP Configuration Task List
- Configuring NTP Implementation Modes
- Configuring Access Control Right
- Configuring NTP Authentication
- Configuring Optional NTP Parameters
- Displaying and Maintaining NTP Configuration
- NTP Configuration Examples
- 1 NTP Configuration
- 27-SSH Operation.pdf
- 1 SSH Configuration
- SSH Overview
- Configuring the SSH Server
- SSH Server Configuration Tasks
- Configuring the Protocol Support for the User Interface
- Generating/Destroying a RSA or DSA Key Pair
- Exporting the RSA or DSA Public Key
- Creating an SSH User and Specify an Authentication Type
- Specifying a Service Type for an SSH User
- Configuring SSH Management
- Configuring the Client Public Key on the Server
- Assigning a Public Key to an SSH User
- Specifying a Source IP Address/Interface for the SSH Server
- Configuring the SSH Client
- Displaying and Maintaining SSH Configuration
- SSH Configuration Examples
- When the Device Acts as the SSH Server and the Authentication Type is Password
- When the Device Acts as an SSH Server and the Authentication Type is Publickey
- When the Switch Acts as an SSH Client and the Authentication Type is Password
- When the Device Acts as an SSH Client and the Authentication Type is Publickey
- When the Device Acts as an SSH Client and First-time authentication is not Supported
- 1 SSH Configuration
- 28-File System Management Operation.pdf
- 29-FTP-SFTP-TFTP Operation.pdf
- 1 FTP and SFTP Configuration
- Introduction to FTP and SFTP
- FTP Configuration
- SFTP Configuration
- 2 TFTP Configuration
- 1 FTP and SFTP Configuration
- 30-Information Center Operation.pdf
- 1 Information Center
- Information Center Overview
- Information Center Configuration
- Introduction to the Information Center Configuration Tasks
- Configuring Synchronous Information Output
- Configuring to Display the Time Stamp with the UTC Time Zone
- Setting to Output System Information to the Console
- Setting to Output System Information to a Monitor Terminal
- Setting to Output System Information to a Log Host
- Setting to Output System Information to the Trap Buffer
- Setting to Output System Information to the Log Buffer
- Setting to Output System Information to the SNMP NMS
- Displaying and Maintaining Information Center
- Information Center Configuration Examples
- 1 Information Center
- 31-System Maintenance and Debugging Operation.pdf
- 1 Host Configuration File Loading
- 2 Basic System Configuration and Debugging
- 3 Network Connectivity Test
- 4 Device Management
- Introduction to Device Management
- Device Management Configuration
- Displaying and Maintaining the Device Management Configuration
- 32-VLAN-VPN Operation.pdf
- 33-HWPing Operation.pdf
- 34-DNS Operation.pdf
- 35-Smart Link-Monitor Link Operation.pdf
- 36-PoE-PoE Profile Operation.pdf
- 1 PoE Configuration
- PoE Overview
- PoE Configuration
- PoE Configuration Task List
- Enabling the PoE Feature on a Port
- Setting the Maximum Output Power on a Port
- Setting PoE Management Mode and PoE Priority of a Port
- Setting the PoE Mode on a Port
- Configuring the PD Compatibility Detection Function
- Upgrading the PSE Processing Software Online
- Displaying and Maintaining PoE Configuration
- PoE Configuration Example
- 2 PoE Profile Configuration
- 1 PoE Configuration
- 37-Routing Protocol Operation.pdf
- 1 IP Routing Protocol Overview
- 2 Static Route Configuration
- 3 RIP Configuration
- 4 IP Route Policy Configuration
- 38-UDP Helper Operation.pdf
- 39-Appendix.pdf
i
Table of Contents
1 VLAN Overview··········································································································································1-1
VLAN Overview·······································································································································1-1
Introduction to VLAN ·······················································································································1-1
Advantages of VLANs ·····················································································································1-2
How VLAN Works····························································································································1-2
VLAN Interface ································································································································1-4
VLAN Classification·························································································································1-4
Port-Based VLAN····································································································································1-4
Protocol-Based VLAN ·····························································································································1-5
Introduction to Protocol-Based VLAN······························································································1-5
Encapsulation Format of Ethernet Data ··························································································1-5
Procedure for the Switch to Judge Packet Protocol········································································1-7
Encapsulation Formats····················································································································1-7
Implementation of Protocol-Based VLAN························································································1-7
2 VLAN Configuration ··································································································································2-1
VLAN Configuration ································································································································2-1
Configuration Task List····················································································································2-1
Basic VLAN Configuration···············································································································2-1
Basic VLAN Interface Configuration································································································2-2
Displaying and Maintaining VLAN···································································································2-2
Configuring a Port-Based VLAN ·············································································································2-3
Configuring a Port-Based VLAN······································································································2-3
Protocol-Based VLAN Configuration Example················································································2-3
Configuring a Protocol-Based VLAN·······································································································2-5
Configuration Task List····················································································································2-5
Configuring a Protocol Template for a Protocol-Based VLAN ························································2-5
Associating a Port with a Protocol-Based VLAN·············································································2-6
Displaying and Maintaining Protocol-Based VLAN ·········································································2-7
Protocol-Based VLAN Configuration Example················································································2-7