Switch User Manual

3-7
[device-ui-vty0] authentication-mode password
# Set the local password to 123456 (in plain text).
[device-ui-vty0] set authentication password simple 123456
# Specify commands of level 2 are available to users logging in to VTY 0.
[device-ui-vty0] user privilege level 2
# Configure Telnet protocol is supported.
[device-ui-vty0] protocol inbound telnet
# Set the maximum number of lines the screen can contain to 30.
[device-ui-vty0] screen-length 30
# Set the maximum number of commands the history command buffer can store to 20.
[device-ui-vty0] history-command max-size 20
# Set the timeout time to 6 minutes.
[device-ui-vty0] idle-timeout 6
Telnet Configuration with Authentication Mode Being Scheme
Configuration Procedure
Follow these steps to perform Telnet configuration with the authentication mode being scheme:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter the
default ISP
domain view
domain domain-name
Configure the
AAA scheme
to be applied
to the domain
scheme { local | none |
radius-scheme
radius-scheme-name
[ local ] | hwtacacs-scheme
hwtacacs-scheme-name
[ local ] }
Configure
the
authenticati
on scheme
Quit to
system view
quit
Optional
By default, the local AAA scheme is
applied. If you specify to apply the
local AAA scheme, you need to
perform the configuration
concerning local user as well.
If you specify to apply an existing
scheme by providing the
radius-scheme-name argument,
you need to perform the following
configuration as well:
z Perform AAA and RADIUS
configuration on the switching
engine. (Refer to the AAA part
for more.)
z Configure the user name and
password accordingly on the
AAA server. (Refer to the user
manual of the AAA server.)
Create a local user and enter
local user view
local-user user-name
No local user exists by default.
Set the authentication
password for the local user
password { simple | cipher }
password
Required
Specify the service type for
VTY users
service-type telnet [ level
level ]
Required
Quit to system view
quit
—