User Manual
Table Of Contents
- Introduction
- Installing the Wireless Bridge
- Using the Wireless LAN
- Configuring the Wireless Client
- Troubleshooting
- Technical Support
- Regulatory Compliance Information
Uninstalling Software Utilities 33
Uninstalling Software
Utilities
If you want to uninstall the 3Com 11 Mbps Wireless LAN software utilities, you
can either use the standard operating system procedure for removing programs or
use the following shortcut procedure:
1 From the Windows Start menu, select Programs, then 3Com 11Mbps Wireless
LAN, then Uninstall 3Com 11Mbps Wireless LAN.
2 When prompted to confirm, click OK.
Updating Ethernet
Bridge Driver
Software
To update your Ethernet Bridge driver software, find your operating system below,
then follow the procedure.
Windows 95,
Windows 98, and
Windows 98 SE
1 Turn on the power to the computer and start Windows.
2 From the Windows Start menu, select Settings, then select Control Panel.
3 Double-click the System icon.
4 Select the Device Manager tab.
5 In the Device Manager Window, expand the Network Adapters list.
6 Select 3Com 3CRWE62092A and click Properties.
7 Select the Driver tab and click Update Driver.
8 In the Update Device Driver Wizard, follow the prompts to install the upgrade.
9 When prompted, click Restart for the changes to take effect.
After the computer restarts, the 3Com 11 Mbps Wireless LAN Setup window
appears, in which you specify the Ethernet Bridge configuration.
10 In the 3Com 11 Mbps Wireless LAN Client Setup window, select Typical and click
Next.
For the fastest installation, it is recommended that you use the typical settings.
You can customize the configuration later. Typical configures the Ethernet Bridge
with the following default values:
WLAN Service Area—Attach to any WLAN Service Area automatically
Security Setting—No security (Open system)
11 In the Summary window, review the Ethernet Bridge setup. To install the software
utilities, check the Start client software installation when finished box.
12 If the 3Com WLAN Launcher is already running, it is recommended that you exit it
and end the Ethernet Bridge service routine by doing the following:
a In the Windows system tray, right-click the 3Com icon and select Exit.
b Press Ctrl+Alt+Delete to bring up the Close Program window.
c In the Close Program window, select SR Services and click End Task.
13 Click Finish to complete the Ethernet Bridge setup and start the software utilities
installation.
The 3Com 11 Mbps Wireless LAN Setup program starts.