User Manual
Table Of Contents
- Introduction
- Installing the Access Point
- Access Point Security
- Configuring the Access Point 8000
- Installing the Device Manager
- Launching a Wireless Device Configuration
- Using the Configuration Management System
- Changing Access Point Properties
- Setting Network Properties
- Setting Data Transmission Properties
- Setting Advanced Data Transmission Properties
- Setting up Security
- Setting up a User AccessList
- Setting up a MAC Address Access List
- Defining RADIUS Servers
- Configuring for SNMP Management
- Defining a TFTP Server
- Setting up a SystemLog
- Upgrading the System
- Changing the Administration Password
- Restoring Factory Defaults
- Resetting the Access Point
- Backing up Configurations
- Restoring Configurations
- Viewing Statistics
- Viewing System Status
- Conducting a Site Survey
- Troubleshooting
- Technical Support
- Regulatory Compliance Information
- Index
Placing the Access Point 7
Mounting on a Wall To mount an access point on a wall, follow the instructions on the mounting
template supplied in the box and refer to the following illustration. Preferably,
mount the access point near the ceiling above any obstructions that could block
transmission. Position the antenna so that the arms point out and away from the
access point at a 45˚ angle
1
2
3
4