User's Guide

Enabling Encryption on
the Wireless Client
This procedure describes how to enable encryption on the wireless client. Refer to
the Access Point User Guide for instructions on how to enable encryption on the
AP.
1 Go to Start > Settings > Control Panel > Network.
2 Highlight the Wireless LAN Card, click on the Properties tab.
3 Click on the Wireless LAN tab,
4 Click on the Advanced button.
5 Select the Encryption tab.
6 Change the current Encryption setting from the default "No encryption" to 40-bit
or 128-bit (USA) or 40-bit (-E1 product, non-USA).
7 Select Shared Keys.
8 Click OK in the Advanced Properties window to save changes.
9 Click OK to exit the 3Com Wireless LAN WLAN Easy Setup window.
10 Click OK to exit the Network window.
11 Reboot the system.
Exhibit 8: User's Manual