Network Router User Manual
Table Of Contents
- V7122 Digital Gateway Installation Guide
- About This Guide
- How to Use This Guide
- Conventions
- Model Numbers for the V7122 Gateways
- Documentation Comments
- Notices
- Chapter 1: Quick Start
- Chapter 2: Installing the V7122 Gateway
- Chapter 3: Configuring the V7122 Gateway
- Chapter 4: Changing the V7122 Gateway Username and Password
- Chapter 5: Restoring and Backing Up the V7122 Gateway Configuration
- Chapter 6: Monitoring the V7122 Gateway
- Chapter 7: Upgrading the V7122 Gateway
- Chapter 8: Regulatory Information
- Appendix A: Obtaining Support for Your 3Com Product
- About This Guide
V7122 gateway completes the restart, Ready and LAN LEDs on the front panel are lit
green.
10 After the gateway is reset, configure the V7122 gateway trunk parameters. For
information about configuring the trunk parameters, see
Configuring the Trunk Settings.
SIP users should continue with Section Configuring the Trunk Settings.
The following sections from here, up to the end of this Guide, apply equally to H.323,
and SIP.
Configuring the Trunk Settings
To configure the trunk settings, follow these 14 steps:
1 Access the Embedded Web Server (see
Accessing the Embedded Web Server).
2 Open the Trunk Settings screen (Advanced Configuration menu > Trunk Settings); the
Trunk Settings screen is displayed.
Initially, the screen appears with the parameters fields grayed (indicating read-only). The
Stop Trunk button appears at the bottom of the screen. The Trunk Status indicators
appear colored.
Table 7 shows the possible indicators and their descriptions.
Figure 15 Trunk Settings Screen
V7122 Digital Gateway Installation Guide
33