Network Card User Manual

iii
Menu Option 4..........................................................................2-15
Assigning timing source priority ............................................ 2-15
Menu Option 5..........................................................................2-15
Configuring chassis slot devices ............................................2-15
Menu Option 6..........................................................................2-16
Configuring the modem routing method .............................. 2-16
Menu Option 7..........................................................................2-16
Configuring the UI console password.................................... 2-16
Menu Option 8..........................................................................2-16
Enabling automatic DS0 state change ................................... 2-16
Menu Option 9..........................................................................2-17
Companding Code Configuration.........................................2-17
Configuring Software Fault Event Logging....................................... 2-17
3
D
UAL
T1/PRI M
AINTENANCE
Dual T1/PRI Commands..................................................................... 3-1
Menu Option 1............................................................................ 3-2
Resetting the highest priority timing source.............................3-2
Menu Option 2............................................................................ 3-2
Resetting the PRI NAC.............................................................3-2
Menu Option 3............................................................................ 3-2
Enter/Exit span-to-span pass-thru loopback mode ................... 3-2
Menu Options 4 and 6................................................................. 3-3
Forcing receiver reframe on the span lines............................... 3-3
Menu Options 5 and 7................................................................. 3-3
Disconnecting calls on specific span line B-channels ................3-3
Menu Option 8............................................................................ 3-3
Forcing the NAC to master the TDM bus................................. 3-3
Menu Options 9 and 10............................................................... 3-3
Entering and exiting locally initiated loopbacks on the
span lines................................................................................ 3-3
Menu Option 11 ..........................................................................3-4
Disabling red ALARM LEDs......................................................3-4
Menu Options 12 and 13.............................................................3-4
Connect/disconnect B-channel on span lines 1 and 2 .............. 3-4
Menu Options 14 and 15.............................................................3-4
Changing individual DS0 service states....................................3-4