User manual
Table Of Contents
- OfficeConnect® Ethernet Hub 16C
- 3Com Corporation n 5400 Bayfront Plaza n Santa Clara, California n 95052-8145
- Before You Start
- Workstation Connections
- 1 10BASE-T connections for all your equipment. 3Com produce a range of easy to install network ad...
- 2 An operating system (for example, Netware or Windows 95/98) with network support configured, ru...
- 3 One ‘Straight-through’ 10BASE-T cable for every workstation or piece of equipment. A ‘Straight-...
- Hub Connections
- Workstation Connections
- Stacking the Units together
- The Rubber Feet
- The Stacking Clip
- 1 Place your unit on a flat surface.
- 2 Fit the clip across the top of the unit, as shown in Figure 2 (picture 1), ensuring that the lo...
- 3 Align the fastening pieces over the slots found on each side of the unit.
- 4 Push the clip down gently to secure it, ensuring the fastening pieces snap into the slots on th...
- 1 Rest the second unit on top of the clip and align it with the front of the unit below.
- 2 Press down gently on the unit to secure it onto the clip, ensuring the fastening pieces fit int...
- Figure 2 Stacking Your Units Together
- Positioning Your OfficeConnect Hub
- Securing the OfficeConnect Hub
- Connecting Workstations and Other Equipment to Your Hub
- Connecting OfficeConnect Hubs Together
- Dimensions and Operating Conditions
- Standards
- Online Technical Services
- 3Com Knowledgebase Web Services
- Support from Your Network Supplier
- Support from 3Com
- Returning Products forRepair
- Hardware
- Software
- Year 2000 Warranty
- Obtaining Warranty Service
- Warranties Exclusive
- Limitation of Liability
- Disclaimer
- Governing Law
- FCC Statement
- CSA Statement
- VCCI Statement
- BCIQ Statement
- Information To The User
10
Positioning Your OfficeConnect Hub
When installing your OfficeConnect hub, ensure:
■
It is out of direct sunlight and away from sources of
heat.
■
Cabling is away from power lines, fluorescent lighting
fixtures, and sources of electrical noise such as radios,
transmitters and broadband amplifiers.
■
Water or moisture cannot enter the case of the unit.
■
Air flow around the unit and through the vents in the
side of the case is not restricted. We recommend you
provide a minimum of 25.4 mm (1in.) clearance.
Securing the OfficeConnect Hub
There are two slots on the underside of the OfficeConnect
hub which can be used for wall mounting. It is
recommended that you mount the hubs with the LEDs
facing upwards to prevent dust entering the cooling vents.
When wall mounting the unit, ensure that it is within
reach of the power outlet.
You need two suitable screws. Ensure that the wall you are
going to use is smooth, flat, dry and sturdy. Make two
screw holes which are 142mm (5.6in.) apart. Use the guide
at the back of this manual to mark the position of the
holes. Fix the screws into the wall, leaving their heads 3mm
(0.12in.) clear of the wall surface.
Remove any connections to the unit and locate it over the
screw heads. When in line, gently push the unit on to the
wall and move it downwards to secure. When making
connections, be careful not to push the unit up and off the
wall.
CAUTION: Only wall mount single units, do not wall
mount stacked units.
Also available from 3Com, is the OfficeConnect Mounting
Unit (part number 3C16765). This allows you to firmly
secure a stack of OfficeConnect devices to the desktop or
onto a shelf in a rack.
3C16702.book Page 10 Tuesday, July 13, 1999 10:16 AM