User guide

Examples 129
Figure 63 Specify Source Device Example
7 Select Next to display the Specify Devices to Setup step and select all of
the devices listed so that the configuration of the source device is applied
to all the remaining new switches.
8 Select Next to display the Summary step and select Finish to start the
Device Setup operation. You must wait until the operation has completed
successfully.
9 Now that all of the new switches have the desired port security and VLAN
settings, you can configure each of the switches with any individual
settings that they require. You should also give each device the IP address
that you will use to manage it once it has been added to your network.
10 Finally, disconnect the new devices from your management station and
add them to the edge of your network. Once HP OpenView has
discovered your new switches, you can re-import the 3Com Network
Administrator inventory file in order to backup their configuration and
perform other administrative tasks.
3Com Network Administrator for HP OpenView.book Page 129 Wednesday, November 12, 2003 2:33 PM