User guide

Setup Components 119
Setup Components The following section describes how to use the Device Setup feature of
3Com Network Administrator.
Device Setup Wizard You can apply a software configuration to one or more target devices.
The software configuration you choose to apply to the target device can
be either the software configuration of a device on your network or a
software configuration saved in a backup file. The target device (or
devices) you choose to set up must have the same physical configuration
as the source device of the software configuration.
The Device Setup Wizard can be launched from Device > Setup.
Configuration Source Type Step
You can choose whether the software configuration that will be applied
to your target devices should come from either a ‘live’ device on your
network or a saved backup as shown in Figure 54
.
Figure 54 Device Setup Wizard - Configuration Source Type
Specify Source Device Step
When you choose to use a ‘live’ device on your network as the source
software configuration, the Device Setup Wizard shows the Specify
Source Device step as shown in Figure 55
:
3Com Network Administrator for HP OpenView.book Page 119 Wednesday, November 12, 2003 2:33 PM