User guide

118 CHAPTER 6: BACKUP, RESTORE AND SETUP
The Device Restore Progress dialog can be ‘minimized’ to the status bar of
the application by clicking Minimize in the bottom left hand corner of the
Progress dialog.
You can cancel the Device Restore operation at any time. If you do cancel
the operation then the configuration of the target device may be left in
an inconsistent state.
Device Restore Event An alarm will be generated in HP OpenView for the Device Restore
operation. The alarm source is the IP address of the target device and
both the alarm severity and the alarm message indicate whether the
attempt to restore the saved software configuration to the device was
successful. The detail of the alarm message for a successful operation
includes the label of the backup that was applied to the target device.
The detail of the alarm message for an unsuccessful operation describes
what went wrong.
You can view the Restore Summary report at any time after the operation
has completed from the History tab of the Reports dialog, launched from
Tools > Reports.
Restore Summary
Report
When the Device Restore operation completes, the Restore Summary
report is automatically generated. You can choose to view the report
from the Device Restore Summary dialog that is shown at the end of the
operation.
The Restore Summary report details the following:
■ The label and description of the saved backup that the Device Restore
operation attempted to apply to the target device.
■ The details of the target device for the operation
■ The result of the Device Restore operation including a further
explanation where appropriate.
You can view the Restore Summary report at any time after the operation
have completed from the History tab of the Reports dialog, launched
from Tools > Reports.
3Com Network Administrator for HP OpenView.book Page 118 Wednesday, November 12, 2003 2:33 PM