User guide

116 CHAPTER 6: BACKUP, RESTORE AND SETUP
You must select the device that has been replaced by your target device
from the table, as shown in Figure 52
.
Figure 52 Device Restore Wizard - Specify Device Being Replaced
The table shows the name of all devices that have one or more existing
backups and have the same physical configuration as your target device.
The list of devices is taken from the saved backup files. The device that is
being replaced does not have to be present in the current inventory file.
Once you have specified the device that has been replaced, all existing
backups for that device will be associated with the target device after the
Device Restore operation has completed successfully.
Specify Backup to Use Step
If the target device has one or more existing backup files associated with
it, the Specify Backup To Use step is displayed. The wizard also shows this
step after the Specify Device Being Replaced step.
The Specify Backup To Use step shows a table of existing backups
associated with either the target device or the device that has been
replaced, as shown in Figure 53
.
3Com Network Administrator for HP OpenView.book Page 116 Wednesday, November 12, 2003 2:33 PM