ATM Switch/Control Module User's Guide

Upgrading FPGA Picocode in ATM Modules
To upgrade hardware picocode in the FPGA of 6416SW and ATM media modules,
enter the following commands at the directory prompt:
1. SET TFTP SERVER_IP_ADDRESS (to define the server where the picocode is
stored)
2. SET TFTP FILE_NAME (to define the file on the server)
3. SET TFTP FILE_TYPE (to specify FPGA)
4. SET TFTP TARGET_MODULE (to specify the slot number of the 6416SW or ATM
media module)
5. DOWNLOAD INBAND (to load new hardware picocode)
6. SWAP FPGA_PICOCODE (to change the picocode in the module). This causes an
automatic reset of the ATM subsystem.
Uploading Dumps
To upload a dump to the host, enter the following 6416SW commands at the directory
prompt:
1. DUMP TRS (to take a dump of the topology of the network)
2. SET TFTP SERVER_IP_ADDRESS (to define the server connected to the 6416SW
module)
3. SET TFTP FILE_NAME (to define the path name of the file on the host)
4. SET TFTP FILE_TYPE (to specify a dump)
5. UPLOAD INBAND (to upload the dump).
6-7