Switch User Manual
Table Of Contents
- 00-Cover.pdf
- 01-text.pdf
- 1 Product Overview
- 2 Preparing for Installation
- 3 Installing the Switch
- 4 Starting and Configuring the Switch
- 5 Boot ROM and Host Software Loading
- 6 Maintenance and Troubleshooting
4-4
Step3 Click OK after selecting a serial port. The following dialog box appears. Set Bits per second to 19200,
Data bits to 8, Parity to None, Stop bits to 1, and Flow control to None.
Figure 4-5 Set the serial port parameters
Step4 Click OK after setting the serial port parameters and the system enters the HyperTerminal window
shown below.
Figure 4-6 HyperTerminal window