Switch User Manual
Table Of Contents
- 00-Cover.pdf
- 01-text.pdf
- 1 Product Overview
- 2 Preparing for Installation
- 3 Installing the Switch
- 4 Starting and Configuring the Switch
- 5 Boot ROM and Host Software Loading
- 6 Maintenance and Troubleshooting
4-3
z Data bits: 8
z Parity: None
z Stop bits: 1
z Flow control: None
z Emulation: VT100
The specific procedure is as follows:
Step1 Select Start > Programs > Accessories > Communications > HyperTerminal to enter the
HyperTerminal window. The Connection Description dialog box appears, as shown below.
Figure 4-3 Connection description of the HyperTerminal
Step2 Type the name of the new connection in the Name text box and click OK. The following dialog box
appears. Select the serial port to be used from the Connect using drop-down list.
Figure 4-4 Set the serial port used by the HyperTerminal connection