User Manual

40 CHAPTER 4: INSTALLING AND CONFIGURING IN NETWARE
send timeout
This command sets the timeout value, in seconds, that the software waits before
retransmitting a probe packet when a send request to the link support layer (LSL)
is not acknowledged. A message is displayed for each loaded frame type.
ungroup
This command deletes a group. The LAN driver for the group must not be loaded.
The following message appears for all frame types that the NIC supports:
Cleaning up resources for group associated with Primary
Slot #xxxx.
wait timeout
This command sets the timeout value, in seconds, that the software waits before
marking a NIC that is in wait mode as failed (see retry count). If no argument is
specified or if the specified argument is invalid, the current value is displayed.
Otherwise, the new value is displayed.
Syntax lbrsl send timeout pri_slot seconds
where:
pri_slot is the PCI slot number of the primary NIC.
seconds is the time in seconds.
Example lbrsl send timeout 1001 10
Default 10
Syntax lbrsl ungroup pri_slot
where:
pri_slot is the PCI slot number of the primary NIC.
Example lbrsl ungroup 10001
Default None
Syntax lbrsl wait timeout seconds
where:
seconds is any positive integer.
Example lbrsl wait timeout 2
Default 1