User Manual

Configuring Groups 39
link timeout
When a group is being created, the software waits the number of seconds
specified by this command for the link/topology check to finish and then displays
timeout information.
probe interval
This command sets the probe packet interval. If no argument is specified or the
specified argument is invalid, the current value is displayed. Otherwise, the new
value is displayed.
receive timeout
This command sets the receive timeout individually for each group and displays a
message for each loaded frame type.
retry count
This command sets the number of retries that the software attempts when a
probe packet fails to appear at the receive end. After the retries, the software puts
the board in Wait mode. If no argument is specified or the specified argument is
invalid, the current value is displayed. Otherwise, the new value is displayed.
Syntax lbrsl link timeout seconds
where:
seconds is the time in seconds.
Example lbrsl link timeout 10
Default 5
Syntax lbrsl probe interval seconds
where seconds is the interval in seconds.
Example lbrsl set probe interval 1
Default 1 second
If the delay is longer than 1 second, NIC or link failures are not recognized as
quickly.
Syntax lbrsl receive timeout pri_slot seconds
where:
pri_slot is the PCI slot number of the primary NIC.
seconds is the time in seconds
Example lbrsl receive timeout 10001 1
Default 1 second
Syntax lbrsl retry count number_of_retries
where:
number_of_retries is any positive integer
Example lbrsl retry count 2
Default 5