User Manual

30 CHAPTER 4: INSTALLING AND CONFIGURING IN NETWARE
Install Server Features Two drivers are associated with DynamicAccess technology server features under
NetWare: SE and LBRSL.
1 From the Configuration Options screen select Product options.
2 Select Install a product not listed.
The following message appears:
Product will be installed from A:\. If you are installing
from floppy, insert the first diskette of the product you
want to install into the drive and verify that the path
above is correct.
Press <F3> to specify a different path;
Press <ENTER> to continue.
3 Press F3.
4 Enter this path:
ecd210p980x:\nwserver
The following message appears:
Product “3Com DynamicAccess Server Features” was found.
Verify that this is the product you want to install before
proceeding.
Press <ENTER> to continue.
Press <ESC> to abort installation.
5 Press Enter.
The system copies the DynamicAccess technology server features software to the
SYS volume.
Configure Groups
1 Press Esc to return to the Installation Options screen.
2 From the Configuration Options screen, select NCF files options (create/edit server
startup files)
3 Select Edit AUTOEXEC.NCF file.
4 Make the following changes to the AUTOEXEC.NCF file:
■ Add a command to load the SE and LBRSL drivers before any commands to
load LAN drivers. For example:
load se
load lbrsl
■ Add or verify the LOAD commands for the LAN drivers for all slot-frame
instances.
■ For each Load Balancing/RSL group, load the same protocols and frame
types on the primary and all secondary NICs.
■ On the primary NIC only, bind a protocol to each slot-frame instance.
■ Remove any protocol BIND commands from each secondary NIC.