User Manual

Installation and Configuration Instructions 29

7 Enter a path to the volume that contains the driver. For example:

ecd210p980x:/nwserver

The Select a Driver to Install screen appears with the 3Com EtherLink Server NIC

driver name highlighted.

8 Press Enter to select the driver.

9 Select Yes at the prompt to conﬁrm the name of the driver to copy.

The installation program copies the driver to the appropriate server subdirectory.

The Conﬁguration screen appears.

Specify the Slot Number You need not specify the slot number if you are installing only one NIC.

1 In the Conﬁguration screen, select Slot Number.

2 Enter the slot number of the NIC that you want to install. For example:

10001

See Changing NetWare Driver Conﬁguration Parameters for instructions on

changing other parameters in this screen.

Load the Driver

1 Select Save parameters and load driver.

The installation program loads the conﬁgured driver and then writes the

appropriate LOAD and BIND commands to the AUTOEXEC.NCF ﬁle.

The system assigns a network number.

2 Enter a network number, or press Enter to select the system-assigned number.

If no errors are encountered, the installation program asks whether you want to

select an additional network driver.

3 Select Yes to set up another NIC.

Set Up Another NIC

1 Follow the prompts for another NIC:

■ Select the driver

■ Enter the slot number

■ Save parameters and load the driver

2 Repeat the process for all NICs to be set up.

3 After all NICs are set up, press Esc several times to return to the Installation

Options screen.