User Manual

DynamicAccess Server Features 23
Specifying Traffic
Priorities (Windows NT
4.0 Only)
You can use the DynamicAccess Software Setup window to specify traffic
priorities.
1 Double-click the 3Com DynamicAccess icon in the Windows Control Panel.
The DynamicAccess Software Setup window appears.
2 Click the appropriate tab:
■ Traffic Prioritization—Prioritize applications to ease bottlenecks in the
network and allow critical applications to take network precedence. You can
turn traffic prioritization on or off independently for:
■ Each NIC that is not in a group and does not have VLANs
■ Each group that does not have VLANs
■ Each VLAN
■ Each virtual NIC (NIC, group, or VLAN) shown in the Traffic Prioritization
control panel
■ Administration—Set DynamicAccess control panel access, set VLAN options,
enable efficient multicast control, and enable the prioritizing of multicast
traffic.
Saving the
Configuration
To save and exit, click OK.
A prompt asks whether you want to configure traffic prioritization. If you click Yes,
the DynamicAccess Software Setup window appears.
To exit without saving the configuration, click Cancel.
Disabling Load
Balancing for a Group
1 Click the Load Balance/RSL tab.
2 In the Load Balance/RSL window:
■ Select a group from the Load Balancing/RSL Groups list.
■ Click Properties.
3 In the Group Properties dialog box:
To disable receive load balancing only—Clear the Receive Load Balance
Enabled check box.
To disable all load balancing—Clear the Receive Load Balance Enabled and the
Transmit Load Balance Enabled check boxes.
4 Click OK.
For detailed information on DynamicAccess software, go to:
http://www.3com.com/dynamicaccess