User Manual

____________________________________________________________________________________
MAXX 6T Owner’s Manual Page 125
APPENDIX J - CONNECTOR SPECIFICATIONS
Audio XLR-3 Connector Pinout
Signals appearing on the XLR connectors are determined by the setting of the internal
Analog/Digital Audio Selection jumpers.
Pin BALANCED ANALOG AES/EBU DIGITAL
1 SHIELD ( FRAME GROUND ) SHIELD ( FRAME GROUND )
2 " + " OR HOT D IGITAL +
3 " – " OR COMMON D IGITAL -
S HELL F RAME GROUND F RAME GROUND
Serial Control Connector Pinout
Pin
EIA-422, DB9-F
Connector
1 GND
2 Transmit A (TX–)
3 Receive B (RX+)
4 GND
5 N/C
6 GND
7 Transmit B (TX+)
8 Receive A (RX-)
9 GND
Shell Frame ground
BNC Connectors
The following note applies to all video, LTC, and Genlock connectors:
• A BNC connector used as an output will have a 75-ohm source impedance.
• A BNC connector used as an input will have a fixed 75-ohm termination.