Manual

Instant Replay Owner's Manual Page 27
CHAPTER TWO – The Rear Panel
INSTANT REPLAY REAR PANEL
ELECTRICAL POWER
CAUTION!
CONNECT THIS PRODUCT ONLY TO AN AC POWER SOURCE WITHIN THE VOLTAGE AND
FREQUENCY RANGE INDICATED ON THE REAR PANEL. THE PRODUCT IS SUPPLIED WITH A
DETACHABLE IEC TYPE AC LINE CORD APPROPRIATE TO THE COUNTRY TO WHICH THE UNIT
WAS ORIGINALLY DELIVERED. CHECK TO SEE THAT IT MATCHES THE ELECTRICAL OUTLET
YOU WILL BE USING.
WARNING:
REPLACE POWER CORD ONLY WITH UNDERWRITERS LABORATORIES (UL) LISTED CORD OF
EQUIVALENT TYPE AND RATING!
Power Switch
The POWER SWITCH is located next to the AC POWER INPUT on the rear of the product.
Fuses
The fuses in this product are not user replaceable. Failure of a fuse is an indication of other
component failure, and will require service by a qualified repair technician. Contact 360 Systems, or
your 360 Systems distributor.
AUDIO CONNECTIONS
Audio Inputs
The ANALOG INPUTS are a pair of female XLR-3 connectors marked LEFT and RIGHT. The inputs are
electronically balanced, with an impedance of 40k ohms. With the INPUT LEVEL controls up full, a
6.75dBu tone will produce a full scale output, approximately 15dBu with the OUTPUT ATTENUATOR
in the –10 position and 25 dBu in the 0 position.
Input cables should be wired as follows:
XLR Connector Pin Balanced Connection Unbalanced Connection
PIN 1 COMMON GROUND
PIN 2 + INPUT SIGNAL
PIN 3 - INPUT No Connect
TABLE OF INPUT AND OUTPUT CONNECTIONS
ITE EQUIPMENT
ATTEN
AES 75 OHM
360 SYSTEMS, WESTLAKE VILLAGE, CALIFORNIA, USA MADE IN USA
OUT
GPI/PLAY
OUTPUT
RIGHTLEFT
ANALOG INPUT ANALOG OUTPUT
LEFT RIGHT
IEC-958 II
AES/EBU DIGITAL
IN OUT
EXPANSION
PRINTER
IN
O
SERIAL #
115-230VAC, 50-60Hz
MODEL #
1.2A MAX
I