- LG Software Innovations Coffeemaker User Manual

Maintenance Page 309 of 378
ITG Trunk 2.0 ISDN Signaling Link (ISL) Description, Installation and Operation
swVersionShow
Print out software version.
resetOm
Reset the Operational Measurement file timer.
logFileOn
Turn on logging.
logFileOff
Turn off logging.
logFileShow
Show if logging is on or off.
logStatus
Show if logging is on or off.
displayClear
Clear the maintenance display on the faceplate of the ITG card.
shellPasswordSet
Change the default ITG shell password.
emodelSim
Allow user to interactively determine QoS score.
itgHelp
Show the complete command list. “?” also shows the list.
itgCallTrace
Shows call trace log.
tLanSpeedSet
Set the Speed of the T-LAN.
tLANDuplexSet
Set the duplex mode of the T-LAN.
logout
Exit the shell.
ping
Test remote host is reachable:
ping<host><numPackets><option>
This command sends an ICMP ECHO_REQUEST packets to a
network hosts. The host matching the destination address in the
packets will respond to the request. If a response is not
returned, the sender will time out. This command is useful to
determine if other hosts or ITG cards are properly
communicating with the sender card. The <numPackets>
parameter specifies how many packets to send; if it is not
included, pings runs until it is stopped by Ctrl-C (which also
exists the ITG shell).
Example: ITG> ping "47.82.33.123", 10
trap_gen
SNMP test alarm (one of each type) generation.
Table 50
General purpose commands (Part 2 of 3)
Command Description