- LG Software Innovations Coffeemaker User Manual

Page 280 of
378
OA&M using the ITG shell CLI and overlays
553-3001-202 Standard 1.00 April 2000
5 Type +++ to bring up the ITG shell command line prompt:
............... +++
When prompted to login, enter the default username and password as:
VxWorks login: itgadmin
Password: itgadmin
ITG>
6 If this card is Leader 0, use the setLeader command:
ITG> setLeader “xxx.xxx.xxx.xxx”, “yyy.yyy.yyy.yyy”,
”zzz.zzz.zzz.zzz”, and press Enter.
Where:
• “xxx.xxx.xxx.xxx” is the IP address of the management
interface on Leader 0,
• where “yyy.yyy.yyy.yyy” is the Gateway IP address for the
management interface on Leader 0. If the MAT ITG PC will be
connected directly to the LAN, and there is no management
LAN gateway, then the Gateway IP address is “0.0.0.0”.
• and where “zzz.zzz.zzz.zzz” is the subnet mask for the
management interface on Leader 0.
7 Do not leave the card with the default user name and password. See
“Change the default ITG shell password to maintain access security”
on page 278.
8 Configure all the ITG cards in the same node with the same password.
Repeat this procedure for other cards in the node.
Download the ITG operational measurements
through the ITG shell
The ITG operational measurements file contains counts of incoming and
outgoing calls, call attempts, calls completed, and total holding time for voice
and fax calls. To download this file from the MAT PC to the ITG card:
ITG>
currOMFilePut
<hostname, username, password, directory path,
filename
> for the current file, or
prevOMFilePut
<hostname, username,
password, directory path, filename
> for the previous file.