SDS

Material Safety Data Sheet – 30 Seconds Spray & Walk Away
Collier Manufacturing, LLC. Trade Name: 30 SECONDS SPRAY & WALK AWAY Page 3 of 5
The following ingredients have established exposure guidelines:
Ingredient
Exposure Guideline
Guideline Value
Ethanol
64-17-5
ACGIH TWA (2002)
1000 ppm (TWA)
NIOSH Pocket Guide
1000 ppm (TWA)
Alberta (Canada)
1000 ppm (TWA), 1250 ppm (STEL)
British Columbia, Manitoba, New Brunswick,
Ontario, Quebec (Canada)
1000 ppm (TWA)
Saskatchewan (Canada)
1880 mg/m
3
(TWA), 2350 mg/m
3
(STEL)
Yukon (Canada)
1000 ppm (TWA), 1000 ppm (STEL)
Mexico – Instruction No. 10
1000 ppm (TWA)
All TWAs are for an 8-hour period and all STELs are for 15 minutes unless specifically noted as being for another time period.
Section 9: Physical & Chemical Properties
Flash Point:
>200°F - Pensky Martin Closed Cup
Specific Gravity:
1.0 (~8.34 lbs/gal)
Percent Volatiles:
ND
Vapor Pressure:
~ 44mm Hg at 68
o
F
VOC Content
ND
Vapor Density:
Estimated to be heavier than air.
Viscosity:
ND
Evaporation Rate:
Not determined.
Pour Point:
Not determined.
pH :
6 –8
Appearance and Odor:
Clear, colorless to straw colored liquid with benzaldehyde (organic) odor.
Section 10: Stability & Reactivity
Chemical Stability:
Material is stable.
Conditions to Avoid:
Keep away from heat and strong oxidizing agents.
Incompatibilities:
Strong oxidizing agents (may result in fire.), reducing agents
Hazardous Decomposition:
Carbon monoxide, carbon dioxide and toxic hydrogen chloride vapors.
Hazardous Polymerization:
Will not occur.
Section 11: Toxicological Information
Carcinogenicity
No Carcinogenicity data available for this product.
Acute Oral LD50
2,940 mg/kg in male and female rats
Acute Dermal
>2,000 mg/kg in male and female rabbits
Primary Skin
Corrosive. Category I
Primary Eye
Corrosive. Category I
Chemicals Ingredients Listed as Potential or Known Carcinogens
Ingredient
OSHA
NTP
IARC
No ingredients listed in this
section.
Section 12: Ecological Information