User Manual

b
In order to change the leg angle or to stow away your tripod you will
need to pull down on the leg catch (a) maneuver the leg into the
desired position and then release the catch.
To open and extend the tripod legs simply grip the friction locks
(b) in your hand quarter turn, loosening the legs allowing you
to select a desired height. Once the required height has been
obtained lock the legs in place by rotating back to the original
position, which will fully engage the leg lock. The friction locks do
not require to be undone further than a half turn, unless you intend
to completely disassemble the legs for cleaning.
Legs, catches & locks
a
It is advised that you wash your tripod after using it in salt
water or sand and this can be done by undoing each leg.
Take each individual leg lock and unscrew until completely
undone, and gently pull the tubing (a) out, being careful
not to lose the green plastic shim (b) (chicken lips), allowing
you to clean the threads of the legs. Once cleaned, ensure
that the green chicken lips are in place and then carefully
insert the leg, lining up the internal slot with the gap (c) in the
chicken lips, and tighten the leg lock in place.
Cleaning
a
b
a
b
c
a
The monopod leg is denoted by a thin orange ring (a) on one
of the leg hinges and can be unscrewed directly from the leg
hinge. Screw the detached leg into the bottom of the centre
column (after rst removing the column from the tripod) to
make the monopod.
The Monopod Leg