SDS

Page 3 of 5
8 – Exposure Controls/Personal Protection
Chemical
Occupational Exposure Limits
Petroleum Base Oils
5 mg/m3 TWA (Inhalable) ACGIH TLV (as mineral oil)
5 mg/m3 TWA OSHA PEL (as oil mist, mineral)
Non-Hazardous Ingredients
None Established
LVP Aliphatic Hydrocarbon
1200 mg/m3 TWA (manufacturer recommended)
Propane
1000 ppm TWA OSHA PEL
Aliphatic Hydrocarbon
1200 mg/m3 TWA (manufacturer recommended)
The Following Controls are Recommended for Normal Consumer Use of this Product
Appropriate Engineering Controls: Use in a well-ventilated area.
Personal Protection:
Eye Protection: Avoid eye contact. Always spray away from your face.
Skin Protection: Avoid prolonged skin contact. Chemical resistant gloves recommended for operations
where skin contact is likely.
Respiratory Protection: None needed for normal use with adequate ventilation.
For Bulk Processing or Workplace Use the Following Controls are Recommended
Appropriate Engineering Controls: Use adequate general and local exhaust ventilation to maintain
exposure levels below that occupational exposure limits.
Personal Protection:
Eye Protection: Safety goggles recommended where eye contact is possible.
Skin Protection: Wear chemical resistant gloves.
Respiratory Protection: None required if ventilation is adequate. If the occupational exposure limits are
exceeded, wear a NIOSH approved respirator. Respirator selection and use should be based on contaminant
type, form and concentration. Follow OSHA 1910.134, ANSI Z88.2 and good Industrial Hygiene practice.
Work/Hygiene Practices: Wash with soap and water after handling.
9 – Physical and Chemical Properties
Appearance:
Light amber liquid
Flammable Limits:
(Solvent Portion)
LEL: 0.6% UEL: 8%
Odor:
Mild petroleum odor
Vapor Pressure:
Not established
Odor Threshold:
Not established
Vapor Density:
Greater than 1 (air=1)
pH:
Not Applicable
Relative Density:
Not determined
Melting/Freezing Point:
Not established
Solubilities:
Insoluble in water
Boiling Point/Range:
430 - 520F (221 -
271°C)
Partition Coefficient; n-
octanol/water:
Not established
Flash Point:
>156F (69°C) Tag
Closed Cup (estimated)
Autoignition
Temperature:
Not established
Evaporation Rate:
Not established
Decomposition
Temperature:
Not established
Flammability (solid, gas):
Extremely Flammable
Aerosol
Viscosity:
Not established
VOC:
Not established
Pour Point:
Not established
Aerosol Flame Extension
(16CFR):
>18 inches
Flashback:
Yes
10 – Stability and Reactivity
Reactivity: Not reactive under normal conditions
Chemical Stability: Stable
Possibility of Hazardous Reactions: May react with strong oxidizers generating heat.
Conditions to Avoid: Avoid heat, sparks, flames and other sources of ignition. Do not puncture or incinerate
containers.
Incompatible Materials: Strong oxidizing agents.