SDS
Page 3 of 5
8 – Exposure Controls/Personal Protection
Chemical
Occupational Exposure Limits
Aliphatic Petroleum Distillates
1200 mg/m3 TWA (manufacturer recommended)
Liquefied Petroleum Gas
1000 ppm STEL ACGIH TLV (as butane)
1000 ppm TWA OSHA PEL (as propane)
Polydimethylsiloxane
None Established
White mineral oil
5 mg/m3 (inhalable) TWA ACGIH TLV
5 mg/m3 TWA OSHA PEL
The Following Controls are Recommended for Normal Consumer Use of this Product
Appropriate Engineering Controls: Use in a well-ventilated area.
Personal Protection:
Eye Protection: Avoid eye contact. Always spray away from your face.
Skin Protection: Avoid prolonged skin contact. Chemical resistant gloves recommended for operations
where skin contact is likely.
Respiratory Protection: None needed for normal use with adequate ventilation.
For Bulk Processing or Workplace Use the Following Controls are Recommended
Appropriate Engineering Controls: Use adequate general and local exhaust ventilation to maintain
exposure levels below that occupational exposure limits.
Personal Protection:
Eye Protection: Safety goggles recommended where eye contact is possible.
Skin Protection: Wear chemical resistant gloves.
Respiratory Protection: None required if ventilation is adequate. If the occupational exposure limits are
exceeded, wear a NIOSH approved respirator. Respirator selection and use should be based on contaminant
type, form and concentration. Follow OSHA 1910.134, ANSI Z88.2 and good Industrial Hygiene practice.
Work/Hygiene Practices: Wash with soap and water after handling.
9 – Physical and Chemical Properties
Appearance:
Clear, aerosol spray
Flammable Limits:
(Solvent Portion)
LEL: 0.6% UEL:9.5%
Odor:
Petroleum odor
Vapor Pressure:
40-60 psig @ 21.1°C
(70°F)
Odor Threshold:
Not established
Vapor Density:
Greater than 1 (air=1)
pH:
Not Applicable
Relative Density:
0.81
Melting/Freezing Point:
Not established
Solubilities:
Insoluble in water
Boiling Point/Range:
161-257°C (322-495°F)
(Petroleum Solvent)
Partition Coefficient; n-
octanol/water:
Not established
Flash Point:
-34°C (-29.2°F) (closed
cup) liquid
Autoignition
Temperature:
Not established
Evaporation Rate:
Not established
Decomposition
Temperature:
Not established
Flammability (solid, gas):
Flammable Aerosol
Viscosity:
Not established
VOC:
49%
Pour Point:
Not established
10 – Stability and Reactivity
Reactivity: Not reactive under normal conditions
Chemical Stability: Stable
Possibility of Hazardous Reactions: May react with strong oxidizers generating heat.
Conditions to Avoid: Avoid heat, sparks, flames and other sources of ignition. Do not puncture or incinerate
containers.
Incompatible Materials: Strong oxidizing agents.