User's Manual

Your value-added selection  3e 
7
(e) Same channel remote controllers shall be installed at least 50M away, to avoid possible
interruption
(f) Ensure cabling is correct & stable
(g) Test the transmitter after installation, ensure every motion is the same as the original wired
control
(h) Fix the original wired control panel in firmed place
NOTE:
Install receiver on the top of control panel firmly, make receiver antenna point to top, so could
receive clear signals from transmitter.
If using instant connector ( optional ) will save lots of time in installation, plug in the
cable & lock with springs, push out springs to take connector out.
Hercules receiver contains perfect design for security / safety purpose, receiver may stop
automatically when interference occurred.
Using 4 screws with electric
screw driver
( fig.4 ) receiver installation
Avoid receiver be
installed inside the
control panel or on the
top
dual-color LED shall be seen
easily from ground
Warning :
a. Every output contact current shall never over 5A.
b. Re-power on receiver ONLY if cabling is correct and has been
double-checked, or may cause unnecessary damage.
6