User's Manual

Our duty is ensure your safety, so you can rely on an excellent device
Transmitter
Technical Specifications ☺
 Take dual-security design, equipment protected thoroughly, every output will automatically break
when CPU out of work.
 Take common mode non-earth ground EMI noise-rejection circuit, which can against receiver
malfunction occurred by operator’s error connection, also releasing the installation complex.
Frequency range:
300 MHz ( 20 channels ) – for Asian.
433 MHz ( 20 channels ) – for American
868 MHz ( 20 channels ) –for Europe
Channel spacing: 50KHz , 60KHz
Transmitting power: < 10mW ( 10dBm )
Antenna: Internal type, impedance as 50Ω
Security codes: 256 sets
Operation temperature: 0°C ~ +70°C
Enclosure: IP65
Source voltage: 4xAA ( 1.5V )alkaline batteries
or nickel rechargeable batteries
Consumption: < 7mA
Size: 217×70×49 mm
Weight: 515g
Frequency range:
300 MHz ( 20 channels ) – for Asian
433 MHz ( 20 channels ) – for American use.
868 MHz ( 20 channels ) – for Europe use.
Channel spacing: 50KHz , 60KHz
Antenna: Internal type, impedance as 50Ω
Relay: 5A, 250V, AC
Operation temperature: -10°C ~ +70°C
Enclosure: IP65
Source voltage: 220V AC, 50 / 60Hz (STD)
Consumption: < 12W
Size: 250×120×75 mm
Weight: 1080g
How to install ☺
It would be very easy to install APOLLO receiver, the necessary tools are as following:
Long nose pliers diagonal cutting pliers cross head screwdriver
Hexagonal head wrench multimeter Electric drill Cable and feeder
Steps:
(a) Ensure the original wired control of crane is correct.
(b) Ensure shut down the main power source of crane before installation.
(c) Mount in a firmed site where the receiver can be seen easily by operator.
(d) Keep away the mounted site from motors, relays, cables, high voltage wiring and devices, or the
protrusion of building where crane moves. Select a firmed site without metal shielding around.
(e) Do not install the other same channel remote controller within 50 meters.
(f) Ensure the wiring layout correctly and safely.
(g) Test each motion / function after installation, ensure transmitter output have the same motion as
the original wired control.
Receiver