Manual
Product Description
1.1
8
1.1 Product Description
Basic Features
The primary purpose of is to transmit voice between GSM
network and attached phone terminals. You can connect terminal with FXO
interface (trunk line of PBX, phone set, answering machine etc.) to FXS
interface on (connector with phone icon) and terminal with
FXS interface (extension line of PBX) to FXO interface on
(connector with crossed out phone icon).
You can establish data connections (GPRS, CSD) and send/receive SMS using
in combination with a PC and appropriate software.
You can send an SMS to a pre-programmed number using the SMS sending
input.
Analogue fax transmission on some models.
Advantages of 2N® SmartGate use
Call cost cutting the calls are routed to GSM or analog network according
to their number prefix. Route all GSM calls from PBX to to
save a lot on PSTN GSM calls.
Easy installation you can easy program as you need with
enclosed SW.
You get all you need in the delivery your delivery
contains all you need to operate the system (the power supply adapter,
telephone cables, PC serial cable, SMS input connector, CD-ROM with
software).
Solution for sites without telephone lines such as mountain chalets,
exhibitions, conferences, etc.
DialThru technology all your calls will be routed most cost-effective way.
ME – Mobility Extension you newer miss an incoming call from analog
network. Incoming call will ring on connected phone and on your mobile
phone too.
CLIP - is equipped with the FSK-based CLIP feature, so if a
Quick data connection transmits data using the high-
speed GPRS connection (GPRS class 10, max. 85.6 kbps).
SMS sending input simply send an SMS to a pre-programmed number by
closing the contact. Recommended for easy supervision, simple securing, etc.
Radiation hazard minimization you are not exposed to a direct effect of
the antenna RF electromagnetic field while telephoning as opposed to mobile
telephones.
Full GSM coverage - is available as quadband (850, 900,
1800, 1900MHz).