User guide

862N TELEKOMUNIKACE a.s., www.2n.cz
®
6.5 LOG Files
Table of LOG Events:
Type Text Description
POWER [Power on] System switched on
[Power off] System switched off
[Warm boot] Restart of system, unknown cause
[Watchdog] Restart of system by watchdog
[BKPT code] CPU error: break code detected
[Stack error] CPU error: stock integrity failure
[Divided by
zero]
CPU error: dividing by zero
[RETI code] CPU error: illegal using of instruction reti
[NMI intr] CPU error: wrong interrupt
[VOID intr] CPU error: wrong interrupt
[Upgrade reset] Start of upgrade firmware procedure
[Software
reset]
Reset by AT commands (at&fres…)
INIT Eeprom Initialisation of eeprom (configuration)
Flash Initialization of flash memory (firmware)
HW–ERR
(##…address of chip, RD…read value/WR…expected
value)
Duart
#####,RD/WR
Error in initialization of serial controller on GSM board
SYSERR
User stack
error!
SW error: stock integrity failure
BRDIN #08 TYP STS the board inserted (number of gsm board, type, status)
BRDOUT #08 TYP STS the board disconnected
BRDRES #08 TYP STS Reset the board by AT command
ALL GSM
RESET CMD
Reset of all GSM boards by AT command
SYSTEM RESET
CMD
Reset of system by command at&bsys
L1–ERR (reserved)
L2–ERR Error of 2. ISDN layer by Q.921
A: unsol.RX(F) Received packed RR,RNR,REJ with unexpected bit F=1
B: unsol.DM(F) Received packed DM with unexpected bit F=1
C: unsol.UA(F) Received packed UA with unexpected bit F=1
D: unsol.UA(–) Received packed UA with unexpected bit F=0
E: unsol.DM(–) Received packed DM with unexpected bit F=0