User guide

822N TELEKOMUNIKACE a.s., www.2n.cz
®
GSM Layer Statuses
GSM Layer 2 Message Status
ID Name Description Follows
0 INIT GSM module initialization start PINREQ
1 SIM0 Module switch to internal SIM card INIT
2 PINREQ Module PIN request PINSET
3 PINSET PIN value sensing to module INFO
4 BLOCK
Module blocked temporarily or permanently (see Layer 2
information)
INIT
5 SETUP Module configuration running IDLE
6 SLEEP Module sleep running (transition to BLOCK status) BLOCK
7 NWAIT Awaiting GSM log–in SETUP
8 IDLE
Rest status, can start/receive call, execute AT&G
command
CALL/CMD
9 CALL Call running (call establishing, connected call, call end) IDLE
10 CMD Communicating with module upon AT&G command IDLE
13 INFO Information loading from module and SIM card NWAIT
GSM Layer 2 BLOCK Message Status
ID Name Description
41 (block)
Blocked by AT&G command, terminated by module, board or
system reset
42 Netw–reg
GSM log–in refused (not activated SIM), next attempt in 5..60
minutes
43 Clir–err CLIR activation request refused, next attempt in 2..10 minutes
44 Mod–err
Defective or not connected GSM module, next attempt in 2
minutes
45 Pin–err Wrong PIN, permanently in BLOCK status
46 Sim–err Defective or not inserted SIM card, next attempt in 2 minutes
47 Log–out Temporarily logged–out according to parameter X00
48 Puk–req SIM card requires PUK
(undef) This position of SIM card wasn't checked by gateway