User guide

382N TELEKOMUNIKACE a.s., www.2n.cz
®
4.1 Ethernet Interface
The BRI gateway can be fully configured via the web interface at
. Make sure that a device equipped with a web browser (PC,http://IP_gateway_address
NB, Tablet, etc.) has been connected for successful connection to the BRI gateway
configuration interface. The device also supports configuration via an extended AT
command set on the Telnet interface (IP port 23).
Tip
The device also supports configuration via an extended AT
command set on the Telnet interface (IP port 23). Refer to Subs.
, page for details.6
The BRI gateway supports DHCP (client). By default, the DHCP support is disabled.
Tip
If DHCP is active, use specialised detection software (for LANs
only) to identify the assigned IP address. Refer to the
web sites, BRI Gateways (IP Scanner) for thewww.2n.cz
software.
Use the web configuration interface in the Gateway configuration – Ethernet
section to set the Ethernet interface.configuration
Ethernet Interface Factory Settings
IPv4 address 192.168.1.2
IP mask 255.255.255.0
User name Admin
User password 2n
Caution
Change the user name and password during your gatewayfirst
configuration to avoid unauthorised access to your gateway
configuration! Refer to page for details!
Tip
In the event of data loss or configuration interface unavailability,
perform the factory reset to retrieve the data. Doing so,
however, you reset all the default values in your gateway. Refer
to , p. for details.Subs. 4.4
MAC Address
The BRI gateway has a unique, factory–set MAC (Media Access Control) address. Refer
to the rear side label of your device or the gateway web interface for the MAC address.