Manual

Table of Parameters 3.2
40
Caution!
n Configuration using phone line programming (DTMF) is applicable for line
‘Other prefixes’ only.
Prefix Function No.: -
Dialed number prefix identifying the call type. "Other numbers" line is used for
calls with prefixes that are not included in the table.
Setting options: 0-16 characters (0-9,*,#)
Default setting: blank
Call enable Function No.: 391
This parameter allows/bars calls with corresponding prefixes.
Setting options: YES(1)/NO(0)
Default setting: YES
Route to Function No.: 392
The Route to parameter defines call routing corresponding to the row.
Setting options: GSM(0) – call is routed only to UMTS/GSM
FXO(1) - call is routed only to FXO interface
GSM, FXO(2) – call is primary routed to UMTS/GSM and
by GSM error is routed to FXO interface
FXO, GSM(3) – call is primary routed to FXO interface
and by FXO error is routed to UMTS/GSM network
Default setting: GSM
Number length Function No.: 393
The parameter defines the expected length of dialed number. It enables to start
dialing into UMTS/GSM or FXO interface immediately after the last digit is dialed.
If the telephone number to be dialed is shorter, a timeout is respected. The "0"
setting means that the function is disabled.
Setting options: 0, 3-15
Setting step: 1
Default setting: 0
End with # Function No.: 394
This parameter enables to establish the call when a # is received. The #
character is removed from the dialed number. If a # should be part of the dialed
number, this function cannot be used for the given prefix.
Setting options: YES(1)/NO(0)
Default setting: NO
Remove Function No.: 395
The Remove parameter is used for automatic call routing. A defined count of
digits (prefix) is removed from the number beginning.
Setting options: 0-20
Setting step: 1
Default setting: 0