Manual

Table of Parameters

3.2

Reception volume Function No.: 191

See FXS interface parameters.

„BabyCall“ – Automatic call

BabyCall number Function No.: 280

If 2N® SmartGate UMTS is programmed as FXO gateway, parameter defines a

number to be dialed for the automatic call function. If this item is blank, the

function is disabled. If only character ‘#’ is included, after BabyCall timeout

elapsed the interfaces FXO and FXS are connected and dialing to PSTN over FXO

interface is possible.

Setting options: 0-20 characters (0-9,*,#,+)

Default setting: blank

BabyCall timeout [s] Function No.: 281

If 2N® SmartGate UMTS is programmed as FXO gateway, parameter defines

time between line Off-Hook and automatic call beginning (if enabled). During

this timeout 2N® SmartGate UMTS waits for dialing that cancels the automatic

call. You can make standard call if the BabyCall function is enabled.

Setting options: 0-255 s

Setting step: 1 s

Default setting: 0 s

Mobility extension FLASH

Mobility Extension FLASH DTMF code Function No.: 240

Fill in DTMF code to enable GSM FLASH function. If 2N® SmartGate UMTS

receive DTMF dialing corresponding to filled code during UMTS/GSM - FXO call, it

generates FLASH to FXO interface.

Setting options: 0-4 characters (0-9,*,#)

Default setting: blank

FLASH length [ms] Function No.: 241

Time of current loop interruption (line On-Hook) during FLASH.

Setting options: 100-1500 ms

Step: 100 ms

Default setting: 100 ms

FXS routing table parameters

All parameters related to the dialed number and call routing are arranged in three

routing tables. Each table pertains to one interface: FXS, FXO and GSM(UMTS).

According to the prefix of dialed number on FXS interface you can: