User's Manual

FAQs
74
13 FAQs
How can I adjust the volumes of the instruments to each other?
For this purpose you have an internal mixer in the mode UNIT on the page MIX (see page 41). Refer also
to the detailed explanations on this topic starting on page 63.
How can I save my settings?
Changes can be saved in both modes UNIT and KIT at the main page (KIT PROG respectively UNIT MIX)
by pressing the left DATA button. Any changes you made in the respective areas are indicated by a "?".
Refer also to page 21 and page 41. In order to be able to save, you have to have the SAVE function
enabled on the page PREF in the mode UNIT (see page 59).
How can I optimize the response behavior of the hihat to my needs?
Special configuration options for the hi-hat can be found in the mode UNIT on the pages HPED (see page
49) and TRIG (see page 43). In any case, you should calibrate the hihat properly. It is also recommended
that you experiment with the trigger-curves and GAIN. Please note that an electronic hi-hat always
responds somewhat different from a normal hi-hat.
How can I assign a different sound to the Rim?
Call up the page DRUM in the mode KIT and select the desired PERC channel by simultaneously pressing
the MORE button and the respective Drum Channel button. Now you can assign a sound to the PERC
channel as accustomed (see also page 29).
How can I avoid double triggers?
At first, you should check the tension of the heads of the affected pads. It should be even and not too
loose. You should also make sure that the pad is mounted properly and does not vibrate too much. If you
still have problems with double triggers, you can change the trigger settings (GAIN and THRES) on the
Page TRIG in the mode UNIT. See section 10.2 UNIT – TRIG* starting on page 43.
How do I assign individual drum channels to direct outputs?
The DrumIt Three provides many routing options. Read from page 63 on, what settings you need to make
in order to assign individual channels directly to specific outputs.