User's Manual

Saving Your Settings
36
8.7 KIT – EQ
Each KIT is equipped with a 3-band EQ with a semi-parametric mid band.
CURVE Shows you a graphical view of the EQ settings made. Pressing the left DATA button
(over CURVE) resets the equalizer. Pressing the button again restores the deleted
setting.
FREQ Select the desired frequency for the mid band with the DATA button. Frequencies from
125 Hz to 8 kHz in octave steps are at your disposal. You can also set the desired
frequency by using the rotary control. Press the controller and hold the MORE button.
The display changes to MID. Now you can fine-tune the cutoff frequency of the mid band
with a 1/3-octave equalizer in the range from 100 Hz to 10 kHz.
BUS Select here which signals should be routed to the KIT-EQ. The choices are:
Drum: The drum channels are routed individually through the EQ. Turn on the EQ on
the page VOL separately for every channel you want.
Mix: The EQ settings are applied to the internal mixer. All drum channels are
automatically routed through the EQ.
Sub: The EQ settings are applied to the internal SUB-mix and automatically affect all
drum channels that are routed to the sub-mix.
Live Sound
If you want to process only certain instruments of your KIT with the EQ, e.g. to give the snare
a little more mids without changing the tom sound, then select "Drum" as bus setting and turn
on the EQ on page VOL only for the snare.
LOW The low band has a shelf characteristic, the cutoff frequency is 80Hz. You can cut or
boost in a range from -12 to +12 dB. In addition, a high-pass filter at 80 Hz is available.