SDS

Page 3 of 5
Conditions for Safe Storage: Store in original container in areas inaccessible to children in a cool, dry, well-
ventilated area. Do not store at elevated temperatures. Avoid heat and direct sunlight.
8 – Exposure Controls/Personal Protection
Chemical
Occupational Exposure Limits
Cocoamide MEA
None Established
Sodium Sulfate
None Established
Sodium Lauryl Sulfate
None Established
Acid Blue #9
None Established
Pine Oil
None Established
Sodium Chloride
None Established
The Following Controls are Recommended for Normal Consumer Use of this Product
Appropriate Engineering Controls: No special controls required for normal use.
Personal Protection:
Eye Protection: None normally required. Prevent eye contact. When opening, hold plastic pouch away from
face.
Skin Protection: Avoid skin contact. Wear rubber gloves when handling product.
Respiratory Protection: None required for normal use.
For Bulk Processing or Workplace Use the Following Controls are Recommended
Appropriate Engineering Controls: Use with adequate general ventilation or local exhaust to minimize
exposure levels.
Personal Protection:
Eye Protection: Chemical safety goggles recommended.
Skin Protection: Wear rubber gloves and protective clothing as required to prevent skin contact.
Respiratory Protection: None required for handling finished product. If exposure levels are excessive, wear
an approved respirator. Selection of respiratory protection depends on the contaminant type, form and
concentration. Follow OSHA 1910.134, ANSI Z88.2 and good Industrial Hygiene practice.
Work/Hygiene Practices: Prevent contact with the eyes, skin and clothing. Wash thoroughly after handling.
9 – Physical and Chemical Properties
Appearance:
Blue Solid
Flammable Limits:
Not applicable
Odor:
Pleasant odor
Vapor Pressure:
Not applicable
Odor Threshold:
Not established
Vapor Density:
Not applicable
pH:
Not established
Relative Density:
Not established
Melting/Freezing Point:
Not established
Solubilities:
100% Soluble in water
Boiling Point/Range:
Not established
Partition Coefficient; n-
octanol/water:
Not established
Flash Point:
None
Autoignition
Temperature:
Not established
Evaporation Rate:
<1 (butyl acetate=1)
Decomposition
Temperature:
Not established
Flammability (solid, gas):
Not established
Viscosity:
Not applicable
VOC:
2%
Pour Point:
Not applicable
10 – Stability and Reactivity
Reactivity: Not reactive under normal conditions
Chemical Stability: Stable
Possibility of Hazardous Reactions: Hazardous polymerization will not occur.
Conditions to Avoid: Avoid high temperatures and direct sunlight.
Incompatible Materials: Acids, bases, moisture, reducing agents, readily utilizable materials including
flammable and combustible materials.