Daim Ntawv Qhia Tus Neeg Siv

AQ251486498741en-010605 | 1© Danfoss | 2023.03
NovoCon® S - High Accuracy Actuator
Operating Guide
❶
IP54
IP54
IP54
 
❸
❺
①
②
❼
NovoCon® analog cable
❻
Manuel Calibration: Press button ①
until two LED’s are turned on, and
then release again.
DIP switch: ②
Manual override: Adjust wheel ③
③
②
①
Common ground shall be
used for all devices on the
same network.
Digital port
Port for CO6 actuator or Energy cable, I/O cable,
analog cable or voltage booster.
Digital port
❷ ❹
Actuator NovoCon® ChangeOver
6
Flexible
 
Cable NovoCon®
Temperature I/O
Red Power 24V (in/out)
Black Power ground (in/out)
Blue Ground T1, T2, V/mA input & V output signal
Grey V/mA input signal or Flow sensor
White V output signal
T1
T2
DN 15 - 32
NO presetting!
DN 15, 20
10 [100 %]
DN 25, 32
100 %
②
①
NovoCon® S / 73690900
NovoCon® Energy cable
- PT1000 surface sensors
NovoCon® Energy cable
- PT1000 immersed sensors
Red Power 24V
Black GND
Grey Analog input or Flow sensor
Blue Analog input ground
NovoCon® digital cable
Red Power
Black
Green ´+´ non-inverting signal wire
White/green ´−´ inverting signal wire
Common ground for power
and bus signal wire
Purple O-ring
Actuator NovoCon®
ChangeOver
6
Red Power 24V
Black GND
White CO6 Control signal
Grey CO6 Feedback signal
Blue O-ring
Actuator NovoCon®
ChangeOver
6
Energy
NovoCon®
I/O cable
Red Power 24V
Black Power ground
Blue Ground T1, T2, V/mA input & V output signal
Grey V/mA input signal or Flow sensor
White V output signal
Yellow T1, resistance input or Flow sensor
Orange T2, resistance input or Flow sensor